Interlogix Concord 4 User Manual - Manual (Page 39)

Concord 4 User Manual 37
Scheduled arming
The scheduled arming feature allows you to arm the panel to Level 3 (away)
according to a schedule. When an active schedule start time is reached, the
panel will exit User Programming, automatically bypass any open sensors, and
arm to Level 3.
The panel will not arm according to an active schedule if the start time is reached
while:
• The panel is already armed to Level 3.
• The panel is performing a phone or sensor test.
Note: Schedules cannot be used to disarm the system.
To schedule arming:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 0660, #.
The touchpad displays AWAY.
3. Press #.
The touchpad displays the first available time schedule as SCHEDULE 00
OFF
, or SCH 00 OFF.
4. Press 2, # to assign the time schedule (on) to arm the panel, or press 1, # to
make the time schedule inactive (off).
5. Press B to go to the next time schedule, or press *, 00, # to exit the
programming menus.
Opening and closing reports
The opening and closing reports feature allows pager holder and/or the central
station to be notified whenever the system is armed and/or disarmed. This
feature can be enabled only by the installer; you do not need to do any additional
programming. If you no longer wish to receive the reports, contact the installer to
turn off this option for your pager.
Opening and closing reports occur without regard to any time schedule. You do
not need to enter any special codes for the page to be sent. Your system can call
up to five different page numbers, as well as the central station, to send an
opening or closing report.
The reports include:
• Opening reports. The panel reports the arming level as 111 (Level 1 – Off)
and the user.