Interlogix Concord 4 User Manual - Manual (Page 30)

28 Concord 4 User Manual
3. Release the button when the desired pitch is heard. After about 15 seconds of
no touchpad activity, the steady tone stops sounding.
System voice volume
If your system includes an optional voice module, you may want to adjust the
volume at which system status messages are announced. To change the voice
volume:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 044.
3. Select a volume level 1 to 7 (7 being the loudest) and press #.
4. Press *, 00, # to exit the programming menus.
Touchpad display brightness
You may want to change the brightness of a touchpad display based on its
location in a building or room. For example, dim the touchpad display in a
bedroom or enhance a display near a window. Changing the touchpad display
affects only the touchpad currently being used.
To change the touchpad display brightness:
1. Enter the programming menus by pressing 9, system or partition master
code.
2. Press 043.
3. Select a brightness level: 0 (off), 1 (low), 2 (medium), or 3 (high), and then
press #.
4. Press *, 00, # to exit the programming menus.
Note: After dimming the display, pressing any button returns the display shortly
to full brightness. After 15 seconds without touchpad activity, the display returns
to the set dimmed level. If an alarm occurs while the display is dimmed, it
automatically returns to the full brightness level and stays that way until you
disarm your system.
Energy saver
Use the optional energy saver feature to keep the premises within a user-
designated temperature range. High and low temperature points that you set
override your normal heating and air conditioning temperature settings. Doing so
allows you to use settings that are more energy-efficient when you are away.