Interlogix Concord 4 User Manual - Manual (Page 46)

44 Concord 4 User Manual
To jump partitions without using an access code:
1. From any hardwired touchpad, press 7, 4.
Touchpads display ENTER PARTITION or ENTER CMD.
2. Press the desired partition number (1 to 6).
The touchpad sounds one short beep if the jump was successful. One long
beep means the jump was not successful. Alphanumeric touchpads display
the text in the newly entered partition.
3. Proceed to arm, disarm, or program as needed.
The partition assignment reverts if no touchpad buttons are pressed for 10
seconds.
Arming and disarming another partition
Any access code that can jump to another partition can control that partition.
Once in the other partition, you must use a valid code for arming and disarming
that partition.
Programming another partition
Only system master and partition master codes can be used for programming.
Only one partition can be programmed at a time. When one partition is in the
programming mode, touchpads in the other partition are locked out from any
programming activity. However, arming and disarming can continue.
Some partition-specific settings share resources, such as access codes and time
schedules. For example, if Partition 1 uses regular user numbers 00 to 20,
Partition 2 will not be able to see or use those user numbers. The first regular
user number available for Partition 2 would be 21.
The allocation of time schedules works in much the same manner. There are 16
schedules that can be used by any partition, but as soon as Partition 1 attaches a
schedule to any event, that schedule cannot be used by another partition, and
vice versa.
Simultaneously arming/disarming multiple partitions
Your system may be set up to let you simultaneously arm and disarm more than
one partition. This can be done from system touchpads or keychain touchpads
assigned to the associated partitions.
Note: Check with your installer to identify which keychain touchpads can
arm/disarm partitions.
To arm multiple partitions at the same time from a touchpad:
1. Press 2 or 3 on any touchpad assigned to one of the partitions you want to
arm.