Interlogix Concord 4 User Manual - Manual (Page 47)

Concord 4 User Manual 45
The display shows ENTER CODE.
2. Enter your access code.
The display shows all the partitions that will be armed.
3. Press # to arm all displayed partitions, or press the number of any partitions
you don’t want armed (the partition numbers disappear from the display), and
then
press #.
To disarm multiple partitions at the same time from a touchpad:
1. Press 1 on any touchpad assigned to one of the partitions you want to disarm.
The display shows ENTER CODE.
2. Enter you access code.
The display shows all the partitions that will be disarmed.
3. Press # to disarm all displayed partitions, or press the number of any
partitions you don’t want disarmed (the partition numbers disappear from the
display), and then press #.
4. If desired, press 4 (no delay) or 6 (latchkey) to activate those features.
Use the following guidelines to arm/disarm multiple partitions from alphanumeric
and fixed display touchpads:
• A partition cannot be armed or disarmed if it is being controlled by another
source at that time. For example, if you are at a Partition 1 touchpad and are
attempting to arm Partitions 1 and 2, a Partition 2 touchpad in use at that
same time prevents arming of that partition.
• Any arming modifiers (4 – no delay, 6 – latchkey) selected at arming apply to
all associated partitions. However, silent arming (5 – silent) only affects the
partition from which you are arming. All other partitions sound exit beeps to
notify occupants that those partitions are arming.
• When arming multiple partitions, any conditions that prevent arming (open,
trouble, active alarm, etc.) are identified on system touchpad displays with the
affected partition number flashing. (If arming from a keychain touchpad, the
condition is displayed on touchpad displays in the affected partition, while
other touchpad displays show PROTEST). The normal protest/auto force arm
sequence follows, or you can press * to cancel the arming request.
• When disarming multiple partitions, any partitions in alarm have the affected
partition number flashing on system touchpad displays. Pressing # cancels all
alarms in the associated partitions. Alarm memory information is then
displayed for all canceled alarms.