Interlogix Concord 4 User Manual - Manual (Page 66)

64 Concord 4 User Manual
If you need more time to complete testing, restart the timer by pressing 8,
code, 3.
Check to see that all sensors have been tested by pressing *. Touchpads
display a list of untested sensors. You will know that you have finished testing
when touchpads display SENSOR TEST OK or ZONES ALL TESTED.
4. Disarm to Level 1 to exit test mode.
Table 13: Sensor test
Device Test procedure Touchpad results
Touchpad Trip a police panic alarm, fire alarm,
and auxiliary panic alarm POLICE OK, FIRE OK,
AUXILIARY OK, POLICE PANIC
OK, FIRE PANIC OK,
AUXILIARY PANIC OK
Wireless touchpad Press the Bypass key ZONES nn OK, TOUCHPAD nn
OK
Keychain touchpad Press and hold the Lock and Unlock
buttons simultaneously for 3 seconds. ZONES nn OK, TOUCHPAD nn
OK
Press and hold the Star and Light
buttons simultaneously for 3 seconds. AUXILIARY OK, AUXILIARY
PANIC OK
Panic button Press and hold the appropriate panic
buttons for 3 seconds. ZONES nn OK, SENSOR nn OK
Door/window sensor Open the secured door or window ZONES nn OK, SENSOR nn OK
Smoke detector Press and hold the test button until the
system sounds transmission beeps ZONES nn OK, SENSOR nn OK
Motion detector Avoid the motion detector view for 5
minutes, and then enter its view. Zones nn OK, SENSOR nn OK
Rate-of-rise heat
detector Rub your hands together until warm,
and then place one hand on the
detector for 30 seconds. ZONES nn OK, SENSOR nn OK
Shock sensor Tap the glass twice, away from the
sensor. Wait at least 30 seconds
before testing again. Zones nn OK, SENSOR nn OK
Phone interface and
voice module Activate a police panic by accessing
the system using the phone and
pressing
*, *, *, *, *, *. POLICE PANIC OK
Glass guard sensor Tap the glass 3 or 4 inches from the
sensor. ZONES nn OK, SENSOR nn OK
Freeze sensor Apply an ice cube wrapped in plastic
to the sensor. Do not allow the sensor
to get wet. ZONES nn OK, SENSOR nn OK