Interlogix XL LCD Keypad Plus User Guide - Manual (Page 11)

21-3600E rev1.3 Welcome Alarm Status Admin Reference 3
If You Are Being Forced to Enter
Protected Premises
A duress (panic) alarm is triggered when you
enter your PIN with the last two digits
reversed. This can be done at reader
keypads, system LCD keypads, and Suite
Security LED keypads.
Normal PIN Example: 1 2 3 4
If being forced to Enter: 1 2 4 3
This feature will be available unless it was disabled
by your service technician when the system was
initially set up.
Logging Into the Keypad
(User ID and/or PIN)
NOTE:
Your Security Representative /
Installer will supply you with your User ID
and PIN number for pressing into the
keypad and logging in to the system.
(The default Master user ID and PIN is:
e.g. ID: 01 or 001, PIN: 7793)
"Logging In" provides you with access to the
features of the LCD keypad. To log in:
Open the keypad
cover, and press in
your user ID number
and/or PIN number
as indicated on the
display.
When finished viewing or entering items, you can
use the
key to exit (press multiple times as
needed--until the "login" screen appears).
Tip:
You will also be logged out automatically if you
do not press any keys for approximately one (1)
minute.
Overview of Screens (Topics)
When logged in, you will see only the topics
that you have the authority to use. Some or all
of the following topics will be available:
Selecting a Topic: Press the " ►" key until your
desired topic appears on-screen. Then press the
key directly under your topic to select it.
Off // Stay // On:
The first screen that
you'll see allows you
to arm or disarm the area(s) as desired, or to
access other topics.
Only two of arm/disarm selections will appear
at a time—depending on the present arming-
state of the area(s).
Off: all intrusion protection fully off.
Stay: partial protection. Internal motion
detectors disabled. Only perimeter protection
on. For users to remain inside the protected
area.
On: all protection fully on. No one remaining in
the protected area.
Status:
This allows checking the status of
various items in the system, or commanding
items into different states.
Please ignore uncommon status screens that may
show up like “Comms, Modem, Licns”. They are for a
service technician’s purposes.
Bypass: This allows bypassing faulty
sensor(s) so the system ignores them, and/or
to allow arming the system.
History: This allows viewing a record of the
tasks that users have performed (disarm
areas, bypass sensors, etc.)
My PIN:
This allows the person who is logged
in to change their password.
Users:
This allows adding or deleting 'users'
from the system, or viewing or editing settings
for specific users.
A "User" is a person who has the authority to login to
system keypads, and/or to gain entry at access-
controlled doors.
Welcome
Enter ID: _ _ _
Your Name Appears
Enter PIN: _ _ _ _
Push ► for Menus
↓Stay ↓On