Interlogix XL LCD Keypad Plus User Guide - Manual (Page 33)

21-3600E rev1.3 Welcome Alarm Status Admin Reference 25
4. Select Edit.
↓?: refers to systems with Suite Security (Condo)
keypads (allows viewing the suite user assignments
for your selected user number). Note: Suite user
assignments can only be set up through the Director
software.
Refer to the details that follow while working with
any of the listed topics:
More:
Provides access to additional screens.
Card:
Enter the card
version number (if
applicable), and the
access-card/token number for this user, and
select Ok when finished.
If card-access (entry at controlled doors) does not
apply, leave the card number as "000000000".
Card Version number support is supplied by your
Security Representative.
Firmware revisions needed for 9-digit card IDs, or
cards with version numbers: Panel firmware
≥
V3.2 ,
and door/elevator controller firmware ≥
V1.5 .
PIN:
This allows
setting or changing
the
P
ersonal
I
D
N umber for this user. (You'll be asked to enter
it twice--to help protect against typing errors.)
The last two digits of the PIN must be different. Also,
do not use consecutive numbers like “1234”.
Name:
Use the
keypad to enter the
user's name, and
select Ok when finished.
Tip: Check the letters on the numeric keypad.
Then, for each letter of the name, press the specific
key until the letter appears (e.g., pressing 2 makes a
2, A, B, C; 0 provides 0, Z, _ <space>, Q, etc).
To move to the next letter-position, use the
► key, or
wait 2 seconds. To retype a previous letter, use the
◄ ► keys, and then enter the letter as before.
Aut:
Use the Next
and Prev buttons to
select an authority
profile for the user. (Select Ok when finished).
This determines what doors the user can enter (and
at what time of day), and the tasks they will be able
to perform at system keypads.
Setting this as Undfnd will delete the user!
User authority profiles themselves are normally set
up by your service technician (service PIN needed).
System
/ Condo (Suite
Security): For
systems with suite
security keypads, this
screen allows
accessing the System authority screen (same
as Aut, above), and the Condo (Suite
Security) authority screen.
Tip: Press “ “ escape key if you do not want to
use this screen.
Use the Next and Prev buttons to select an
authority profile for the user. (Select Ok when
completed).
Condo (Suite Security) Authority of "Undfnd":
This is a reserved suite user (that can be edited by a
user with suite "Master" authority).
Suite Security Authority assignments for a user are
set up through the Director software.
Lang / Chal: This
screen allows setting
the LCD language for
this user, and whether or not the "physically-
challenged" unlock times and door-held-open
times apply to this user.
Select Lang to 'toggle' the language, or Chal
to 'toggle' the "Challenged" setting. When
finished, select Ok.
Watch the screen for the settings to change.
(You will remain in this same screen.)
To return to the main screen (log out), press the
“ “ escape key a few times, or let the system
time-out (1 minute).
0xx ► UserName
↓Edit ↓Delete ↓?
0xx UserName
↓OK vv_nnnnnnnnn
New PIN - - - -
For User 0xx
UserName . . . .
↓OK
0xx AuthProfile
↓Ok ↓Next ↓Prev
0xx UserName
↓System ↓Condo
0xx AuthProfile
↓Ok ↓Next ↓Prev
0xx..Lng:Eng.C:N
↓OK ↓Lang ↓Chal