Interlogix XL LCD Keypad Plus User Guide - Manual (Page 44)

36 xL LCD Keypad User's Guide 21-3600E rev1.3
(option)
The optional Arming Station allows many
system tasks to be performed without having
to login at the LCD Keypad. The following is
an overview of the available commands.
For more information on entering at a controlled door
and/or disarming the system, refer to the "Welcome"
and "Alarm" chapters.
<login>
represents the form of user
identification used e.g. badging card and
or ID – PIN entry.
Be sure to enter all digits of your user-ID and/or PIN
(e.g., 023).
Command Result
<login> only Access
(Momentary unlock of a door)
Command Result
1 <login> Turn Area Off
Command Result
1 0 <login> Turn all Areas Off
ENSURE ALL PROTECTION POINTS ARE
SECURE WHEN ARMING AT THE ARMING STN
If arming to STAY or ON occurs while any number
of non-bypassable protection points are insecure,
the Arming Station will warn the user with audible
and visual indications. The arming station will
make a long buzz and the left and right lights will
flash back and forth. This will also cause an alarm
condition. The user must turn OFF, locate and
correct the problem and attempt arming again. If
the protection point is bypassable, it will be
automatically bypassed when arming is done at the
station. Unless specially programmed, all points
except the entry/exit door ARE bypassable.
Command Result
2 <login> Turn area to Stay
Command Result
3 <login> Turn area On
Command Result
3 0
<login> Turn all Areas On
Command Result
5 <login> Door Commands and
Disarm area
Door Commands
If area is off and door unlocked, door is locked.
If area is off and door locked, door is unlocked.
Disarm Area
If area is on, door locked and user is authorized,
area turns off and door is unlocked.
Command Result
6 <login> Work Late in area by 2
hours at a time from the
current time.
Scheduled area only.
This command can only be used again at the end
of the first entered 2 hours when the arming station
will indicate closing time again with the work late
LED flashing and tones. At that time, this
command can be used again to extend the closing
time another 2 hours.
Command
Result
6 n <login>
Worklate in area for n hrs.
Work Late in this area for “ n “ hours where n = 1 –
9 hours Scheduled area only.
Command Result
7 <login>
Use Armed light to view
area condition for 20
seconds .
Armed light is Green for Area OFF,
Armed light is solid red for Area in STAY
Armed light is flashing red for Area ON.
Command Result
9 <login> Silence alarm (in all areas)
Arming Station Reference