Interlogix XL LCD Keypad Plus User Guide - Manual (Page 6)

iv xL LCD Keypad User's Guide 21-3600E rev1.3
installed, it is the responsibility of the installing
company to ensure that the jack and/or plug is
compliant with the criteria of the
telecommunication industry.
The Ringer Equivalence Number (or REN) is
used to determine the number of devices that
may be connected to a telephone line.
Excessive REN’s on a telephone line may
result in the devices not ringing in response to
an incoming call. In most, but not all areas, the
sum of REN’s should not exceed five (5.0). To
be certain of the number of devices that may
be connected to a line, as determined by the
total REN’s, contact the local telephone
company.
The REN for the xL using the North American
Modem is 0.2
The REN for the xL using the Worldwide
Modem is 0.0
CAUTION: If this equipment (xL) is deemed
potentially harmful to the telephone network,
the telephone company will attempt to notify
you in advance of discontinuing service. . If
advance notice is not practical, the telephone
company will notify you as soon as possible. If
service is disconnected, you will be advised of
your right to file a complaint with the Federal
Communications Commission (FCC) should
you believe it necessary.
The telephone company may make changes
in its facilities, equipment, operations or
procedures that could affect the operation of
this equipment. Should this occur, advance
notice you be provided in order for you to
make necessary modifications to maintain
uninterrupted service.
If trouble is experienced with this equipment
(xL), for repair or warranty information, please
contact the installing company.
If the equipment is causing harm to the
telephone network, the telephone company may
request that you disconnect the equipment until
the problem is resolved.
There are no user serviceable parts which may
be repaired by the customer. All repairs must
be performed by an authorized dealer
representative.
This equipment cannot be used on public coin
phone service provided by the telephone
company. Connection to party line service is
subject to state tariffs. (Contact the state
public utility commission, public service
commission or corporation commission for
information.)
WARNING NOTICE:
NORTH AMERICA
AUSTRALIA
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at their own expense.
This is a class A product. In a domestic
environment this product may cause radio
interference in which case the user may be
required to take adequate protection
measures.
WARNING: Changes or Modifications not expressly
approved by VEREX Technology could void the
user’s authority to operate this equipment.
Restrictions and Requirements for UL
Listed Systems
• Access control is not permitted for UL
listed residential systems.
• The system must be tested on a weekly
basis, including all fire initiating devices.
Please see “Testing Monitored Sensors”
in this manual for details.
• Detectors and fire initiating devices will
be disabled while making programming
changes to the system.