Interlogix XL LCD Keypad Plus User Guide - Manual (Page 18)

10 xL LCD Keypad User's Guide 21-3600E rev1.3
Select View to view
points that are
currently bypassed or
not Ok. At this time the system will indicate
points that are not OK and force you to either
bypass or secure
these points in order
to arm the system.
Select the desired topic:
• Pts: Bypassable points (sensors) in the
displayed area;
• Next: Show the
next area;
• All: All bypassable
points regardless of area.
When a point/sensor is displayed, you'll have
these options:
• "◄►": Press the arrow keys to scan through
the sensors (points) in the system (or the
selected area);
• Bypass: Select this
for the system to
ignore (bypass) the
selected sensor
.
• "?" jumps to the next point that is not OK.
Once all points have
been bypassed or
secured, the system will automatically arm.
After arming (On), leave immediately by the
designated exit route!
The tone you will hear is a reminder for you to
quickly leave the area or premises. During the
last 15 seconds this intermittent tone will
speed up. The exit tones will now stop
sounding and the selected areas are now fully
armed.
Turning Protection OFF
1. When you have entered the area with THE
protection ON, the keypad will beep and
the screen will
display:
2. Enter your user ID and/or PIN to log into
the keypad.
3. This screen will display, to choose turning
the area fully off
or put in Stay for
partial protection.
4. After making your
selection, this
screen will ask if
the protection for all areas should be
changed, if there is more then one area. If
“No” is selected,
this screen will
display the
current condition of the available areas
e.g. “On” and selections for that area.
Selections for other areas are displayed by
pressing ”Nxt” or just change the
protection level for the area you are in.
Pressing the button below “Done” will
process the selections you made.
Turning Protection On by Area
Groups, a Group of Areas or
Individual Areas.
Check with your Security Representative / Installer
to have this feature added to your system. You must
have the proper Authority to control additional
protected areas.
1. Enter your user ID
and/or PIN to log
into the keypad.
2. Select the button
for your desired
protection level.
Selecting “Stay” will supply selections for the
areas separately. Selecting “On” will supply
the special way to turn area protection on.
3. Select Yes if an
authorized user
has been
assigned with the authority level to turn on a
certain group or groups of areas at the same
time.
4. If authorized,
select No to
choose individual
Area Groups or Areas to turn on.
AreaName .....Off
↓Pts ↓Next All↓
xxx :► Sensor Name
Status ↓Bypass ↓?
Arming...Bypass
↓Next Function
Area(s) arming
Please Leave
To Disarm
Enter ID: _ _ _
Push ► for menus
↓Off ↓Stay
Points not Ok!
↓View
All Areas Off?
↓Yes ↓No
Area 1.........On
↓Off ↓Nxt Done↓
Welcome
Enter ID: _ _ _
Push ► for menus
↓Stay ↓On
All Areas ON?
↓Yes ↓No
Choose Area by?
↓Group ↓Area