Keri Systems Doors.NET Manual - Manual (Page 158)

Doors.NET Reference Manual
- 158 -
3. Under the Gateway Selection pull-down list, select the gateway type that matches
your hardware.
l
Keri - NXT Series – for standard Keri NXT hardware
l
Keri - PXL Series – for Keri PXL hardware
l
MSC - SCP Series – for Mercury hardware or for Keri NXT hardware using Mer-
cury firmware
l
ASSA – for ASSA Abloy WiFi and IP hardware
4. The Server IP Address and TCP Port value is automatically entered. This assumes
the access control hardware and the host computer on which the software is
installed are all on the same network.
NOTE: You will need to enter a Server IP Address and TCP Port value if your access
control hardware is on a different subnet from the one on which the host computer is con-
nected. Contact your IT department for this information.
5. Enter the User Name and Password. The default value is “admin” for both of these
fields.
6. Click CONNECT to select an existing Gateway or to create a new Gateway.
7. The Select Gateway tab opens.
View Existing Gateway Information
1. A list of existing Gateways is displayed. Click an existing Gateway name to view
its GUID value.
2. Click NEXT for a closing summary of Gateway information.
Create a New Gateway
1. Click in the Description field and enter a descriptive name.
2. Click ADD GATEWAY. The new Gateway is added to the Existing Gateways list.
3. Click on the Gateway name to select the new Gateway.
4. Click NEXT for a closing summary of Gateway information.