Keri Systems Doors.NET Manual - Manual (Page 438)

Doors.NET Reference Manual
- 438 -
4. Click Save.
Adding Locations
The Locations tab configures which controllers the user group is allowed to manipulate.
Those that are unchecked will not be shown to any login in that user group. In the
example below, the Security Management user group will only see the first PXL500 con-
troller listed on the London Office PXL gateway. It will appear to them as though there is
only 1 PXL on the gateway when in fact there are two. By not being able to 'see' the
second controller, the logins in this user group will not be able to configure, override,
receive messages, or run reports on the second PXL500.
1. Scroll through the list of Available Locations and select the ones you wish this oper-
ator to view.
2. Click Save.
3. Now, if the operator views Hardware Setup there will only be the selected con-
troller and selected gateway listed in the hardware tree - the first controller in the
London Office gateway.