Canon 2010F - Manual (Page 20)

Placing Originals 1-11
Introduction to Cop
ying
1
Orientation
You can place an original either vertically or horizontally. Always align the top edge
of your original with the back edge of the platen glass (by the arrow in the top left
corner), or with the back edge of the feeder.
Platen Glass
Vertical Placement Horizontal Placement
Feeder
Vertical Placement Horizontal Placement
NOTE
• If the top edge of the original is not aligned with the back edge of the platen glass (by the
arrow in the top left corner), prints may not be made correctly, depending on the mode
you have set.
• LTR originals can be placed either vertically or horizontally. However, the scanning speed
for horizontally placed originals is somewhat slower than for vertically placed originals.
You can place originals horizontally when scanning with a Preset Zoom, such as when
enlarging LTR
to 11" x 17" .
• Horizontally placed LTR originals are referred to as LTR .
• 11" x 17" and LGL originals must be placed horizontally.
• To get the same output result when you are using the feeder as when the original is
placed on the platen glass, place the original upside-down and face up in the feeder.
However, when using the Staple mode, the finisher rotates the output automatically.
Place the
original
face down.
Place the original face down.
ABC
Place the
original
face up.
ABC
Place the
original
face up.