Interrupt mode, Interrupt mode -20, See “interrupt mode,” on p. 1-20.) – Canon 2010F User Manual
Page 29
Interrupt Mode
1-20
Introduction to Cop
ying
1
Interrupt Mode
The Interrupt mode enables you to interrupt the reserved or current job that is
printing long enough to make higher priority copies. This mode is useful if you need
to make a rush copy during a long copy job.
NOTE
You can make interrupt copies when the machine is ready to scan.
1
Press [COPY].
lights.
2
Press [Interrupt].
If you want to make copies after changing the Department ID while Department
ID Management is enabled, press
(ID)
➞ enter the Department ID and
password. (See Chapter 2, “Basic Operations,” in the Reference Guide.)
(Interrupt) lights.
NOTE
If you press
(Interrupt), the current job being output is not interrupted until the
interrupt copy starts printing.
3
Place your original, and set the desired copy modes.
NOTE
To cancel the Interrupt mode, press
(Stop)
➞ press
(
▼) or
(
▲)
to select the reserved copy job
➞ press
(CANCEL).
COPY
COPY
Interrupt
ID
F2
F3
F4