Winco DSE7300 Series - Manual (Page 80)

DSE7200 / 7300 Series Operators Manual
80
6.3 SMS CONTROL
NOTE:- Only available in version DSE7300 version 8+ modules with a suitable GSM modem
connected to the RS232 port and configured to receive the control commands.
The SMS Control feature (if enabled) allows the user to send control commands to a DSE7200 via SMS message.
There are five control commands that the user can send to the module, these control commands are in the table
below.
NOTE:- Multiple SMS Control Commands CANNOT be sent in a single SMS message.
Control Command
Number Module Action
1 Start the generator off load if in the ‘Auto’ position.
2 Start the generator on load if in the ‘Auto’ position..
3 Cancel an SMS start request.
4 Put the module into the ‘STOP’ position.
5 Put the module into the ‘AUTO’ position.
To send an SMS command, the user will need (if configured) the SMS Control Pin Number and the Control
Command Number. Only these numbers must be included in the SMS, the module will not respond to any SMS
with extra characters or missing PIN number (if configured). Below is an example how to start and run the
generator on load by SMS message.
NOTE:- There must be a space between the SMS PIN Number and the Control Command Number
SMS Message 1
This SMS message will place the module into the AUTO position.
0123 5
SMS Message 2
This SMS message will start and run the generator on load..
0123 2
SMS Message3 This SMS message will remove the start and run command given by the
previous SMS message and leave the module in the AUTO position
0123 3
SMS Message 4
This SMS message will place the module into the STOP position.
0123 4
Example screen shot of SMS Control setup in the DSE Configuration Suite
6.4 STOP MODE
Pin
Number
Control
Command
Number