Winco DSE7300 Series - Manual (Page 86)

DSE7200 / 7300 Series Operators Manual
86
6.6.3 ENGINE RUNNING
In manual mode, the load is not transferred to the generator unless a ‘loading request’ is made.
A loading request can come from a number of sources.
• Pressing the transfer to generator button
• Mains supply out of limits (DSE7220/DSE7320 only)
• Activation of an auxiliary input that has been configured to remote start on load
• Activation of the inbuilt exercise scheduler if configured for ‘on load’ runs.
NOTE:-The load transfer signal remains inactive until the Oil Pressure has risen. This prevents
excessive wear on the engine.
Once the load has been transferred to the generator, it will not be automatically transferred back to the mains
supply. To manually transfer the load back to the mains either:
• Press the transfer to mains button (DSE7220/DSE7320 only)
• Press the Open Generator button (DSE7210/DSE7310 only)
• Press the auto mode button to return to automatic mode.
For further details of breaker control, see the section entitled “controls and indications” elsewhere in this manual.
6.6.4 MANUAL FUEL PUMP CONTROL
NOTE:-Manual Fuel Pump Control is only available on suitably configured systems with V3 or higher
control modules. Consult your set supplier for further advice.
• Navigate to the instruments page using the buttons and locate FUEL LEVEL. is shown on the
module display to indicate that this feature is available.
• Press and hold the button to energise the transfer pump. The pump starts two seconds after the button
is pressed.
• Release the button to de-energise the transfer pump.
6.6.5 MANUAL SPEED CONTROL
NOTE:-Manual Speed Control is only available on suitably configured systems with V3 or higher
control modules. Consult your set supplier for further advice.
• Navigate to the instruments page using the buttons and locate ENGINE SPEED. is shown on
the module display to indicate that this feature is available.
• Press the button to enter edit mode
• Press (up or down) to change the engine speed.
• Press the button again to exit the editor and leave the engine running at the newly selected speed.