Introduction – YSI ProDSS User Manual
Page 14
Advertising
12
Introduction
Sensor guard weights
To help stabilize the sensors when profiling at deeper depths, a sensor guard weight is supplied with cables 10 meters
and longer. To attach the weight, carefully hand-tighten it clockwise on to the bottom of the sensor guard (
).
NOTICE: If any resistance is felt, loosen the sensor guard weight completely to prevent cross-threading.
Incorrect installation may cause damage to the sensor guard.
The bottom of the weight is threaded so that additional weights can be added if needed. See
NOTE: Do not have any weights installed on the sensor guard when calibrating using the calibration cup.
Advertising