Attaching the feed cover (f), Changing snap-on presser feet (b), (d), (j), (l), Attaching the feed cover – SINGER 57815 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Attaching the feed cover (F)
The feed cover is used to keep the feed from moving the
fabric when attaching a button, darning or sewing free-
motion embroidery. To attach it, follow the directions
below:
• Raise needle and presser foot.
• Open slide plate.
• Slide feed cover on top of needle plate, pressing tabs
(
1
)and (
2
) into holes.
• Close slide plate.
• To remove, open slide plate and lift front edge of
cover; pull it away.
Changing snap-on presser
feet (B), (D), (J), (L)
• Raise needle to its highest position by turning hand
wheel toward you.
• Raise presser foot using presser foot lifter at back of
machine.
• Push toe of presser foot (1) up, until it snaps off the
shank (
2
).
• Remove foot from machine.
• Place new foot under centre of shank.
• Lower presser foot lifter, fitting shank over presser
foot pin (3).
• Don’t turn screw. Instead, push presser foot screw (4)
down, firmly until foot snaps into place.