Winding a bobbin – SINGER 57815 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Winding a bobbin
Winding a bobbin is quick and easy when you follow the
directions
below.
Always
wind
the
bobbin
before
threading the machine and needle.
Push in indent (1) on hand wheel disc. This will stop
the needle form moving.
Place spool of thread on spool pin.
Slide spool cap (2) firmly over rim of spool to prevent
thread tangling.
Lead thread from spool and snap into thread guide
post (3).
Wind thread clockwise around front of bobbin winder
tension disc (4).
Pass thread end, from inside, through small hole in
rim of bobbin.
Place bobbin on spindle and push it to the right.
Holding thread end, step on speed controller to run
machine until desired amount of thread is wound.
(Winding stops automatically once bobbin is full).
Cut thread; push bobbin to the left and remove it from
spindle.
Trim thread end from top of bobbin.
Return hand wheel disc to sewing position by pressing
on side opposite indent.
J
V