Twin needle sewing – SINGER 57815 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S I N G E R
Twin needle sewing
Optional accessory
Caution: Make sure not to set stitch width greater than that
what is recommended when twin needle stitching.
Recommended settings
Stitch Selection: Desired stitch
Needle Position:
Stitch Width:
Stitch Length: 2-5
Foot: General Purpose (B)
Needle Plate: General Purpose (A)
Procedure
• Turn the machine off.
• Insert the twin needle with the flat side of the shank toward
the rear of the machine.
• Thread the machine as you normally would for single needle
stitching, and pass the thread through the left eye of the
twin needle.
• Insert a second spool pin into the hole on the top cover of
the machine, as illustrated.
• Thread the machine in the usual way.
•
Pass the thread through the remaining points, making
certain to omit the thread guide just above the needle and
pass thread through right eye of needle.
• Draw both threads under the foot and back along with the
bobbin thread.
• Slowly lower the needle into the hole in the needle plate by
turning the hand wheel toward you to make sure the needle
clears the plate.