Threading the machine – SINGER 57815 User Manual

Page 28

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

S I N G E R

Threading the machine

Raise take-up lever to highest position by

turning hand wheel toward you.

Raise presser foot to release thread

tension.

Place spool of thread on spool pin.

Slide spool cap firmly over rim of spool to

prevent thread tangling.

Lead thread from spool and snap into

thread guide (

1

) and with only one hand

pass the thread under the guide and

through the slot, as illustrated (

2

).

Thread the tension discs by leading the

thread down and around the tension (3).

Hold the spool lightly and pull the thread

up, lifting the spring and allowing the

thread to slip into thread guard.

Slip thread into take-up lever as illustrated

(4).
Pass thread through guides (5) and (

6

).

Thread needle from front to back, pulling

4” (10cm) of thread through eye (7).

Advertising