Xerox 7042 - Manual (Page 127)

Maintenance Procedures
Error conditions
The following table lists error messages the LCD may display.
Some hardware errors, such as the covers being open, also
cause the Error LED to be lit.
Table 10-2:
En'or
Messages
Message items to Check
Document jam Remove the document from the scanner.
Check the condition of the document. If necessary,
copy the original on a copier.
Check the scanner for obstructions.
Add paper’ Load the paper cassette.
Paper jam Remove the sheet that jammed. Check the printer
for obstructions.
Check that the paper cassette is seated correctly in
the machine.
Change the paper supply.
Remove Document/
Stop
Remove the document from the scanner or press
the STOP key to feed the document to the output
tray.
Cannot do this now The procedure you selected is not available. For
example, you receive this message if you press the
REPORT key when no paper is loaded.
Cover open Close the scanner cover and the printer cover.
Comm, fail nnnz Begin the communication again.
Memory full Print and delete all unnecessary files.
F- full Print and delete all unnecessary files.
No drum unit Install the drum unit.
Drum near end Replace the drum unit.
Change drum unit Replace the drum unit.
Toner empty Replace the toner cartridge.
No counter Install the drum counter.
Warming up Wait until the warmup process completes.
Maintenance Contact the service representative for routine
scheduled maintenance.
System error nnnn Press the power switch OFF. Wait 30 seconds then
press the power switch ON. If the message is
repeated, call your service representative.
The display may show NONE by the paper tray number If the machine has an auxiliary tray installed.
2 nnn indicates an information code.
10-5