Maintenance procedures – Xerox 7042 User Manual
Page 136
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Maintenance Procedures
5.
Holding the developer assembly by the green handles,
align the three shafts on the developer assembly sides
with the slots in the machine frame. The developer
assembly handles align with the green arrow inside the
machine. Lower the assembly into the machine.
The following figure shows how the shafts on the
assembly align with the slots:
6.
Press firmly on the green squares on the drum unit until
the drum unit clicks into place. The following figure
shows how to press the drum unit into place:
7.
Press down on the center portion of the printer cover to
close the cover.
10-14
Advertising