Transmitting – Xerox 7042 User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Transmitting
On-hook and off-hook dialing
The machine allows two modes for dialing: on-hook dialing and
off-hook dialing.
Keypad dialing
During the standby mode, the machine is in an on-hook mode if
the handset is placed on the cradle. In this mode, you can
select any of the dialing methods: however, in some countries,
one-touch dialing is allowed only with off-hook dialing.
To initiate off-hook dialing, lift the handset from the cradle. If you
lift the handset, dial the number and listen for a facsimile tone,
then press the START key to initiate the transmission. You can
perform all the dialing methods in this mode.
NOTE: The handset is not available in some countries.
Use the following procedure to transmit a document using the
control panel keypad to dial the number:
1.
Load the document face-down in the ADF.
2.
If desired, select the resolution and the halftone.
3.
If desired, set the page count and press the START key.
4.
Use the control panel keypad to dial the number.
5.
Press the START key. The machine transmits the
document.
5-6