Programming the machine – Xerox 7042 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Machine
Use the following procedure to program the logo;
1.
Open the access panel.
2.
Press the PROGRAM key and close the access panel.
3.
Press the PAUSE/i key four times to display LOGO.
4.
Press the START key. The LCD prompts you to enter the
logo:
LOGO
NAME/O
-
Complete the following steps to enter the text using the
control panel keypad.
Refer to the Character Code table for the keypad and
character assignments.
a.
Press the keypad number that corresponds to the
character you desire. The first character displays.
b.
Press the keypad number repeatedly until the correct
character displays.
c.
To move to the next position, press the # key.
d.
Perform steps a through c for each character in the
name. You can enter up to 25 characters in the
name.
e.
Verify the name you entered. To change a
character, use the * («-) key and the # (^) key to
move the cursor to that character. Reenter the
character.
6. Press the START key.
3-3