Xerox 7042 - Manual (Page 72)

Transmitting
Manual broadcast dialing
The machine can send a document to up to 50 numbers you dial
manually. You do not have to have the numbers programmed as
a group for this procedure. Use the control panel keypad, the
one-touch keys, or the speed dial codes to enter the numbers.
When the machine begins transmitting the document, the LCD
displays a standby message. If you display the job status, the
LCD then displays the dialing code and the name for each
machine as it dials that number.
Use the following procedure to transmit a document to several
numbers. Only one manual broadcast can be programmed at a
time.
1. Load the document face-down in the ADF.
2. Open the access panel.
3. If desired, select the resolution and the halftone.
4. If desired, set the page count and press the START key.
5. Press the MANUAL BROADCAST key and close the
access panel. The LCD prompts you to enter a one-touch
key, a speed dial code, or the telephone number using the
control panel keypad.
6. Dial a number you want to call.
7. Verify the number you entered. To change the number,
press the CLEAR key and reenter the number.
8. Press the START key.
9. Perform steps 6 through 8 for each number to add to the
manual broadcast group.
10. Press the REPORT key to print the Manual Broadcast List.
11. Verify the numbers you entered.
12. Press the START key. When the transaction completes,
the machine prints a Manual Broadcast Report.
5-10