ADLINK DAQe-2214 - Manual (Page 14)

2 Introduction
1.1 Features
The DAQ/DAQe-2213/2214 advanced data acquisition card has
the following features:
X
32-bit PCI bus (DAQ model) or PCI Express bus (DAQe
model), plug and play
X
Up to 16 single-ended inputs or 8 differential inputs support-
ing combinations of SE and DI analog input signals
X
512-word analog input Channel Gain Queue configuration
size
X 16-bit analog input resolution with up to 250 kHz sampling
rate
X
Programmable bipolar/unipolar analog input
X
Programmable gain: x1, x2, x4, x8
X
A/D FIFO size: 1024 samples
X
Versatile trigger sources: Software trigger, external digital
trigger, analog trigger, and trigger from System Synchroni-
zation Interface (SSI)
X
A/D data transfer: Software polling and bus-mastering DMA
with scatter/gather functionality
X
Four A/D trigger modes including post-trigger, delay-trigger,
pre-trigger and middle-trigger
X Two-channel D/A outputs with waveform generation capa-
bility (only on DAQ-/DAQe-2214)
X
1024 word length output data FIFO for D/A channels (only
on DAQ-/DAQe-2214)
X
Supports System Synchronization Interface (SSI)
X
Full A/D and D/A auto-calibration
X
Jumper-free and software-configurable