Display Devices Lifts up up 400 lbs - Manual (Page 13)

1/17/07 13
Projector Mounting
Most lifts are shipped with the projector mounting adapter attached. Remove it from
the lower frame of the lift, if you have not already done so.
Find the projector’s center of gravity using a dowel, pipe or broom handle.
Invert your projector and attach the mounting adapter to the bottom of the projector
with the enclosed hardware.
Use the Remote Control to lower the lift to a good working height – see the Remote
Control Operation section for further information.
Place the lift in manual mode - use a small point (straightened paperclip) press and hold
the OVERRIDE button then press the UP button. Release UP then release
OVERRIDE.
Test the unit by pressing the DOWN button. It should move only when the button is
depressed. The lift will stop when the button is released.
Attach the adapter to the lift with the projector’s center of gravity under the wire rope
and eye bolts of the lift. If you ordered OPT11- Pre-wire package proceed to Part 7.
Front Back
UP
DOWN
STOP
SET
These two bottoms are accessed with a small point
OVERRIDE