Display Devices Lifts up up 400 lbs - Manual (Page 15)

1/17/07 15
The lift is shipped with a sample cable in the clips – after reviewing the sample cable -
remove. Attach your cables in a likewise manner. Small cable tie wraps are supplied for
securing the cables into the clips.
Use both of the small holes when attaching the cables to the clips. Leave a loop at the
end of each scissor.
Carefully route the projector cables starting at the bottom scissor towards the front of
the lift and work towards the top front of the lift. Be careful you do not allow the
cables to twist.
NOTE:
It is common practice to keep the signal cables (audio, video, RGB) separate from the
projector power and control cables to prevent signal interference. Utilize the clips on
both sides of the lift for isolation.
Raise the lift to its home position with the UP button (in MANUAL mode) slowly,
carefully, and intermittently. Observe carefully the cables rigged to the sides of the lift
and watch for any problems.
Bring the lift down with the DOWN button. Again, watch for any problems and ensure
proper overall operation. Do this several times.
If you did not set the 12-volt trigger and AC configuration, revisit Part 1 and set the Dip
Switches for your system design.
You are now ready to attach the ceiling panel closure system.