Display Devices Lifts up up 400 lbs - Manual (Page 14)

1/17/07 14
Cabling the Lift
Caution:
Using large-diameter RGB and other signal and/or control cable is not
recommended on Display Devices’ lifts.
This type of cable has too large of a bend radius to allow it to fit in the cable
management clips mounted on the outside of the scissor assembly.
If your system uses large cables, keep them coiled neatly to the top of the lift, and
provide an interconnected miniature RGB cable to make the run down through the cable
management clips to the projector.
Attaching the Cables
Using the hand-held remote, bring the lift down to the MAINTENANCE position. See the
separate Remote Manual to learn how to program this position. The signal, power and
control cables can now be routed into the cable management clips on sides of the
scissor assembly.
When routing the cables always start at the fixed end of the scissor on the bottom
frame. Your cable routing will end at the fixed end of the scissor on the top frame.