Display Devices Lifts up up 400 lbs - Manual (Page 23)

1/17/07 23
Program the lift to MANUAL MODE –
To set Show and Service positions the lift must be in Manual Mode.
1. Use a small point (straightened paperclip) press and hold the OVERRIDE button
then press the UP button. Release UP then release OVERRIDE.
2. Test the unit by pressing the DOWN button. It should move only when the button
is depressed. The lift will stop when the button is released.
Set the SHOW position
This is the intermediate level for “on screen” projection. Be sure to start this procedure
from the HOME position.
1. Program the remote to MANUAL MODE (OVERRIDE + UP). Press and hold the
OVERRIDE button, then press the UP button. Release UP, then release
OVERRIDE.
2. Lower the lift with the DOWN button to its desired projection position.
3. To program the remote to the SHOW position, press and hold the SET button then
press the UP button. Release UP, then release SET.
4. To return the remote to the AUTOMATIC MODE, press and hold the OVERRIDE
button, followed by the STOP button. Release STOP, then OVERRIDE.
5. Return the lift to the HOME position by pressing the UP button once.
6. Test the operation of the lift to verify it has accepted your program.
7. Press the DOWN button once. The lift will travel to its programmed position. If the
lift does not travel to the position just programmed, repeat this process.
* Remember, the remote must be in AUTOMATIC MODE for the commands to operate
correctly.
Front Back
UP
DOWN
STOP
SET
These two bottoms are accessed with a small point
OVERRIDE
Front Back
UP
DOWN
STOP
SET
These two bottoms are accessed with a small point
OVERRIDE