Display Devices Lifts up up 400 lbs - Manual (Page 28)

1/17/07 28
Summary of the Remote Control Functions
The OVERRIDE and SET buttons are hidden on the back of the remote control. The
lower button is OVERRIDE and the top button is SET. A straightened paper clip or
similar device will be needed to activate them.
When using the OVERRIDE and SET buttons, these buttons must be pressed first and
released last in the sequence.
To set the show position, press and hold SET, press UP, release UP, and then release
SET.
Automatic Mode:
UP moves lift to the top position, DOWN moves lift to show position, and STOP stops
the motion of the lift.
UP, DOWN, and STOP are functional while the lift is moving.
Manual Mode:
UP and DOWN buttons move the lift only while the buttons are depressed. Unit will stop
at the top limit switch.
STOP stops the motion of the lift at the current position.
OVERRIDE & DOWN from the show position moves the lift to the maintenance position.
OVERRIDE & UP from any position will place the lift into manual mode.
OVERRIDE & STOP terminates the manual mode and returns the lift to automatic mode.
SET & UP sets show position and only works in manual mode.
SET & STOP set the maintenance position and only works in manual mode.
When in the automatic mode, press and hold OVERRIDE, then press STOP & UP
together to place the unit into test mode. This will continually cycle the lift between
home and show positions, pausing at each position. To terminate, press stop.
The NO MOVEMENT switch is located on the control box mounted to the lift frame and
disables all movement of the unit. Remote control buttons become inactive.
EMERGENCY OVERRIDE & UP raises the lift only after the lower safety switch has been
triggered.
Holding the STOP button for 10 seconds will clear the last Communication Code
(blinking LED).