Display Devices Lifts up up 400 lbs - Manual (Page 21)

1/17/07 21
Emergency Operation
If your lift has traveled below the service position, and activated the lower limit safety
switch, you will need to refer to the Remote Manual, and/or follow the steps below.
1) Open the back cover of the handheld remote control case, or remove the switch
plate from the wall box.
(More detailed information is in the Remote Control Manual page 26.)
2) Press and hold the STOP button for 15 seconds to clear the error. Press the
EMERGENCY button in the circuit board, press the UP button and release, then
release the EMERGENCY button. The Lift should travel upward.
3) Verify operation and reprogram positions if necessary. See the Remote Control
Manual enclosed as a supplement.
If the above steps do not resolve the problem, call Technical Support at 303.412.0399
during normal business hours, or E-mail Display Devices, Inc. at
[email protected] .