Display Devices Lifts up up 400 lbs - Manual (Page 22)

1/17/07 22
Remote Control Unit
The Display Devices hand-held Remote Control Unit is a versatile, multi-functional
programmable unit for lift operation.
The UP button moves the lift to the home position in AUTOMATIC mode, and raises the
unit intermittently on command (in MANUAL mode).
The DOWN button lowers the lift to its SHOW position in AUTOMATIC mode, and
lowers the unit intermittently on command in MANUAL mode.
The STOP button stops the lift’s motion while in AUTOMATIC mode.
The OVERRIDE held down then followed by the DOWN button will lower the lift to
service position while in Automatic Mode.
The SET and OVERRIDE buttons on the back of the unit are used in combination with
the three command buttons on the front to program lift functions.
The EMERGENCY OVERRIDE button should only be accessed in case the lower limit
switch is activated. This will be discussed later.
* It is recommended to keep the handheld 9-pin remote attached to the control box in
addition to any control system (Crestron/AMX/etc.) for easy maintenance override or
control system failure.
Front Back
UP
DOWN
STOP
EMERGENCY – accessible only
with back cover removed
SET
These two bottoms are accessed with a small point
OVERRIDE