Display Devices Lifts up up 400 lbs - Manual (Page 16)

1/17/07 16
Ceiling Closure System – CTB Mounts & Sliders
NOTE: If you are not installing an OPT1 Ceiling Closure Frame, proceed to Part 8.
Lower the lift to a workable height. Install the CTB mounts to the corresponding holes
in the front and rear on the lower frame of the lift. (If your system includes the EMRCM
Rotating Option, attach the CTB to the EMRCM lower frame). See the supplemental
EMRCM/LIFT Interface directions.
Use ¼-20 x 1” bolts, ¼” split lock washers, and ¼” flat washers to attach the CTB
mounts to the lower lift frame.
Place the sliders on top of the CTB mount tabs that extend out from the right and left
sides. Add hardware but do not tighten the sliders to the tabs completely as they will
need to be adjusted for alignment.
Option 1 Lipped
Ceiling Closure Frame
Option 1 Lipless
Ceiling Closure Frame
Slider (X2)
Slider (X2)
CTB Mount (X2)
CTB Mount (X2)
Threaded Rod
Assembly (X4)
Threaded Rod
Assembly (X4)