EXFO VDSL2 User Manual
Page 101
Fault Location Tests
Copper, VDSL2, ADSL2+, and IP Triple-Play Test Set
93
RFL Single Pair (2 wire) Test
To set parameter values:
1. To configure a section of cable for the test, press the up/down arrow
keys to highlight the section icon then press
to enable the section.
To disable a section, highlight the section icon then press
.
2. Use the left/right arrow keys to highlight each parameter and press
to open the list or select the value.
3. Press the up/down arrow key to highlight the desired value.
OR
Press the left arrow key to erase the existing value, and then use the
alphanumeric keypad to enter a value. To cancel the entry, press
.
4. Press
to accept the value.
5. Set other parameters as necessary.
6. Configure other sections of the cable as required.
7. Press
to start/stop the test.