EXFO IQS-1700 High Performance Power Meter for IQS-500/600 User Manual
Page 62
Recording Power Signal Variations
54
IQS-1700
2. Select the channel for which you want to see the power variation data
on-screen by clicking the corresponding buttons in the Min./Max. tab.
3. If you want to specify the duration of power measurements, click the
Use Timer button, then enter a span using the arrow buttons on each
side of the list. If you are using the numeric box to enter a time value,
you must enter it in seconds (for example, 120 seconds for 2 minutes).
4. Click Start to start power measurements.
These can be stopped at any time by clicking Stop. If the timer is set,
power measurements will stop automatically after the specified
duration.
Note: The remaining duration is indicated under the Start and Stop button.
The Reset button will reinitialize the Min./Max. acquisition results in the
data display.
Selection
indicators