Datalogic Scanning Matrix 400 - Manual (Page 12)

MATRIX 400™ REFERENCE MANUAL
2
1
Required Accessories
The following table shows the correct lens/illuminator combinations to be used for Matrix
400™ imager assembly.
Lenses Internal Illuminators
93ACC1793 LNS-1006 6 mm C-Mount Lens
(only for Matrix 400 600-0x0 models) 93A401020
93A401022 LT-002
LT-004 Red Wide Angle
White Wide Angle
93ACC1794 LNS-1109 9 mm C-Mount Lens 93A401020
93A401022 LT-002
LT-004 Red Wide Angle
White Wide Angle
93ACC1795 LNS-1112 12.5 mm C-Mount Lens 93A401020
93A401022 LT-002
LT-004 Red Wide Angle
White Wide Angle
93ACC1796 LNS-1116 16 mm C-Mount Lens 93A401019
93A401021 LT-001
LT-003 Red Narrow Angle
White Narrow Angle
93ACC1797 LNS-1125 25 mm C-Mount Lens 93A401019
93A401021 LT-001
LT-003 Red Narrow Angle
White Narrow Angle
93ACC1798 LNS-1135 35 mm C-Mount Lens 93A401024 LT-006 Red Super Narrow Angle
93ACC1799 LNS-1150 50 mm C-Mount Lens 93A401024 LT-006 Red Super Narrow Angle
STEP 2 – CONNECT THE SYSTEM
To connect the system in a Stand Alone configuration, you need the hardware indicated in
Figure 2. In this layout the data is transmitted to the Host on the main serial interface. Data
can also be transmitted on the RS232 auxiliary interface independently from the main
interface selection.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
Figure 2 – Matrix 400™ in Stand Alone Layout
Matrix 400™
Host
PG 6000
P.S.
*
* External Trigger or Presence Sensor
(for One Shot or Phase Mode)
CBX
Main Interface
CAB-MS01
I/O, AUX