Kipp&Zonen COMBILOG Data Logger - Manual (Page 22)

3.5 Connection
 Connection: plug-in screw terminals
 Nominal cross section: 1.5 mm² (0.02 square inch)
unifilar/fine-strand (AWG 16)
 Length of wire stripping : 6 mm (0.2 inch)
 Alternatively available: LP-terminals (spring loaded)
(upon request)
 Protection earth: 6.3mm series tabs at rear
side of housing
The best way to pull off the screw terminals is to use a small
screwdriver, placed as a lever between terminal and the front
of the data logger.
Not more than 2 leads should be connected with one clamp. In
this case the leads should have the same conductor cross sec-
tion.
Note: Wire connection is only allowed during power off.
Note: In order to avoid influences from noise on the sensor sig-
nals shielded wires should be used for the power supply, the
bus connection and the signal lines.
ATTENTION: Before final installation, a suitable protection
earth cable with terminal has to be connected to the ground
connector at the back of the data logger. Assure that the con-
nection has a low impedance after mounting.
Hardware Manual COMBILOG 1022 22