Kipp&Zonen COMBILOG Data Logger - Manual (Page 70)

Channels settings
In order to change the values the press/rotary knob must be
pressed. Thereby a cursor will be set on the first character of
the value. Pressing the knob again moves the cursor one char-
acter to the right. The value at the place of the cursor can be
altered by turning the knob. Clockwise (=upwards) or counter-
clockwise (=downwards).
Note: Depending on the type of channel different settings can
be made.
(1) the definition of offset and factor is possible for the ana-
logue input channel, the digital input channel and the digit-
al output channel. These settings are used to convert the
measurement value from the unit of the measured value to
the unit of the measurement display.
(2) For the setpoint channel a setpoint value can be defined
if this is allowed by the configuration software
COMBILOG.EXE. This value can be used by the data log-
ger for further processing (e.g. for the arithmetic channel).
For the arithmetic channel and the alarm channel no settings
can be made.
Hardware Manual COMBILOG 1022 70