Labconco Protector Work Stations 3930021 - Manual (Page 11)

Product Service 1-800-522-7658 7
Chapter 3:
Getting Started
Now that the site for your Protector Work Station is properly prepared, you are
ready to unpack, inspect, install, and validate your system. Read this chapter to
learn how to:

Unpack and move the enclosure.

Set up the enclosure with the proper supporting structure and work surface.

Connect to an exhaust system (only applicable for remote blower).

Installation of carbon filters (only applicable for integral blower exhausted
to the room).

Connect the electrical supply.

Set the face velocity with the speed control adjustment, only applicable for
integral blower.

Arrange validation for the enclosure.

Seal the enclosure to the work surface.
Depending upon which model you are installing, you may need common
mechanical and electrical installation tools in addition to wrenches, ratchets,
sockets, a nut driver set, a flat-blade screwdriver, a Phillips screwdriver, and a
carpenter level to complete the instructions in this chapter.
Each enclosure weighs either 85 or 105 lbs. each (37 or 46 kg).
The shipping container allows for lifting with a mechanical lift
truck or floor jack. If you must lift the enclosure manually,
follow safe-lifting guidelines.
Do not lift by the front air
foil .
!