Labconco PuriCare Procedure Stations 38100 - Manual (Page 31)

Chapter 5: Using The Cabinet
Product Service 1-800-522-7658 26
Information Center
The Information Center is an LCD display located on the right side wall at
eye level. The center’s display is divided into three separate areas, as shown
in Figure 5-2, below.
Status Area
Data Area
Icon Area
Status Area
The Status Area displays the system’s condition during operation. This line
can display any of the following messages:
OK
The motor is operating properly, and the sash is not open too far.
Sash is too high
The sash is open too far for safe operation.
Airflow Alert
The airflow patterns in the cabinet have changed, resulting in a sudden
change in the motor speed. This is most likely due to a blockage of the
grille or the exhaust filter outlet. It may also be caused by removal of the
work surface while the cabinet is in operation.
System Error
The motor and display circuit board are not communicating properly.
DO NOT USE THE CABINET UNTIL THE PROBLEM HAS BEEN
CORRECTED.
Figure 5-2