Xblue Networks X-44 - Manual (Page 15)

Setup
Installation
Connecting the X-44 Telephone to your existing network only takes a few steps.
It is a good idea to plug each X-44 into an Uninterrupted Power Supply (UPS), which will keep them
functioning during a power outage or use Power Over the Ethernet (PoE) switch, which will allow you to
use one centralized UPS.
1. Remove the contents from the box. For installation of the optional sidecar, refer to
“ Connecting the Sidecar ”
2. When connecting to an existing network, unplug the Ethernet cable from your computer and
plug it into the port labeled , then connected the supplied cable from where your original
cable was plugged into and the other end into the X-44‘s port labeled with symbol.
3. Connect the coiled handset cord to the top port on the left side of the X-44 telephone. If
you are using an ancillary headset connect it to the bottom port on the left side of the X-44.
4. Connect the supplied power supply from the X-44 to the electrical outlet or into the ancillary
UPS System or use a Power Over the Ethernet (PoE) switch (no power supply needed).
Product Overview
15