Xblue Networks X-44 - Manual (Page 63)

Telephone Programming Menu
Menu Programming
Each telephone can be customized by the individual user using either the telephone menu or through a
standard Internet Browser such as Windows Internet Explorer. Press the Menu soft button to enter the
programming area.
From an Idle
X-44 telephone select Menu to change programming parameters, FWD to change where a
call will forward to, DND to place the extension into Do Not Disturb mode, or EXT to scroll through to
locate and dial a specific extension number.
There are 8 different programming menus in the programming area, which are accessed by press the
down navigation button. The following menu options will be displayed.
1. Quick Setup - Used to auto provision telephone lines
2. Phone Settings - To customize Name, Language, and sounds for the telephone
3. User Settings - To customize DND and Call Forwarding parameters
4. VM Setting - Setup Voicemail for your extension
5. Phone Information - for reference only
6. VAA Settings - Voice Auto Attendant Settings - This procedure locks all other telephones.
7. Admin Settings - Network and Interface programming parameters
8. Reboot the telephone
Getting Started
At default, the X-44 is programmed as DHCP. Therefore, when the telephone is plugged into your
existing network it will automatically be assigned an IP Address, extension number and locate any other
X-44 telephones on your network.
At default the extensions are numbered from 101 - 116, but can be changed to accommodate different
three digit numbering plans. When changing the extension numbering remember not to create any
conflicts such as 311, 411, 611, and 911.
Programming can be done using one of the telephones or using an Internet Browser such as Internet
Explorer (Internet Explorer 9 may need to be run in compatibility mode).
Programming Menu
63