Subaru 2006 Legacy User Manual

Page 135

Advertising
background image

3-20

Instruments and controls

„

ABS warning light

The ABS warning light comes on when the

ignition switch is turned to the “ON” posi-

tion and goes out after approximately two

seconds.

This is an indication that the ABS system

is working properly.

The ABS warning light comes on together

with the brake system warning light if the

EBD system becomes faulty. For further

details of the EBD system fault warning,

refer to “Brake system warning light”.

NOTE

If the warning light behavior is as de-

scribed in the following, the ABS sys-

tem may be considered normal.
y

The warning light comes on right af-

ter the engine is started but goes out

immediately, remaining off.
y

The warning light remains on after

the engine has been started, but it goes

out when the vehicle speed reaches

approximately 8 mph (12 km/h).
y

The warning light comes on during

driving, but it goes out immediately

and remains off.

When driving with an insufficient battery

voltage such as when the engine is jump

started, the ABS warning light may come

on. This is due to the low battery voltage

and does not indicate a malfunction.

When the battery becomes fully charged,

the light will go out.

„

Brake system

warning light

The tire pressure monitoring system

is NOT a substitute for manually

checking tire pressure. The tire

pressure should be checked period-

ically (at least monthly) using a tire

gauge. After any change to tire pres-

sure(s), the tire pressure monitoring

system will not re-check tire infla-

tion pressures until the vehicle is

first driven more than 20 mph (32

km/h). Be sure to install the speci-

fied size for the front and rear tires.

If the warning light behaves as fol-

lows, the ABS system may not work

properly.

(U.S.)
(Canada)

When the warning light is on, the

ABS function shuts down; however,

the conventional brake system con-

tinues to operate normally.
y

The warning light does not come

on when the ignition switch is

turned to the “ON” position.

y

The warning light comes on when

the ignition switch is turned to the

“ON” position, but it does not go

out even when the vehicle speed

exceeds approximately 8 mph (12

km/h).

y

The warning light comes on dur-

ing driving.
If any of these conditions occur,

have the ABS system repaired at

the first available opportunity by

your SUBARU dealer.

y

Driving with the brake system

warning light on is dangerous.

This indicates your brake system

may not be working properly. If

the light remains on, have the

brakes inspected by a SUBARU

dealer immediately.

(U.S.)
(Canada)

Advertising