Subaru 2006 Legacy User Manual

Page 294

Advertising
background image

Driving tips

8-15

CONTINUED

The roof rail is not designed to carry cargo

by itself. Cargo can be carried after secur-

ing the roof crossbar kit to the roof rail and

installing the appropriate carrying attach-

ment. When installing the roof crossbar

kit, follow the manufacturer’s instructions.

When you carry cargo on the roof using

the roof crossbar kit and a carrying attach-

ment, never exceed the maximum load

limit explained in the following. You should

also be careful that your vehicle does not

exceed the Gross Vehicle Weight Rating

(GVWR) and front and rear Gross Axle

Weight Rating (GAWR). See the “Loading

your vehicle” section in this chapter for in-

formation on loading cargo into or onto

your vehicle. The maximum load limit of

the cargo, crossbars and carrying attach-

ment must not exceed 100 lbs (45 kg).

Place the heaviest load at the bottom,

nearest the roof, and evenly distribute the

cargo. Always properly secure all cargo.

T Installing carrying attachments on

the crossbars

When installing any carrying attachment

such as a bike carrier, ski carrier, kayak

carrier, cargo basket, etc. on the cross-

bars, follow the manufacturer’s instruc-

tions and make sure that the attachment is

securely fixed to the crossbars. Use only

attachments designed specifically for the

crossbars. A set of the crossbars is de-

signed to carry loads (cargo and attach-

ment) of not more than 100 lbs (45 kg).

Before operating the vehicle, make sure

that the cargo is properly secured on the

attachment.

NOTE

Remember that the vehicle’s center of

gravity is altered with the weight of the

load on the roof, thus affecting the

driving characteristics.

Drive carefully. Avoid rapid starts, hard

cornering and abrupt stops. Crosswind

effects will be increased.

T Removal and installation of the

crossbars

The crossbars can be removed when you

do not use the roof to carry cargo.

V To remove the crossbar

1. Loosen and remove the T-30 torx®

head screw from the top of each crossbar

end support.

Loosen the lower clamps.

y

When using the roof crossbar kit,

make sure that the total weight of

the crossbars, carrying attach-

ment and cargo does not exceed

the maximum load limit. Overload-

ing may cause damage to the ve-

hicle and create a safety hazard.

800239

800240

Advertising