Remote keyless entry sys- tem – Subaru 2006 Legacy User Manual

Page 94

Advertising
background image

Keys and doors

2-7

CONTINUED

All doors and the rear gate (Station wag-

on) can be locked and unlocked by the

power door locking switches located at the

driver’s side and the front passenger’s

side doors.

To lock all doors (including the rear gate of

a Station wagon), push the switch to the

front (“LOCK”) position.

To unlock all doors (including the rear

gate of a Station wagon), pull the switch to

the rear position.

When you close the doors after you set

the door locks, the doors remain locked.

NOTE

Make sure that you do not leave the key

inside the vehicle before locking the

doors from the outside using the pow-

er door locking switches.

„

Key lock-in prevention func-

tion

This function prevents the doors from be-

ing locked with the key still in the ignition

switch.

T Behavior with key lock-in preven-

tion function operative

With the driver’s door open, the doors are

automatically kept unlocked even if the

door locking switch is pushed to the front

(“LOCK”) position.

T Behavior with key lock-in preven-

tion function non-operative

y

If the lock lever is turned to the rear

(“LOCK”) position with the driver’s door

open and the driver’s door is then closed

with the lock lever in that position, the driv-

er’s door is locked.
y

If the spare key is used to lock the driv-

er’s door from the outside of the vehicle,

the door is locked.

This function’s operative/non-operative

setting can be changed by a SUBARU

dealer. Contact a SUBARU dealer for de-

tails.

NOTE

When leaving the vehicle, make sure

you are holding the key before locking

the doors.

Remote keyless entry sys-

tem

This device complies with Part 15 of

the FCC Rules and with RSS-210 of In-

dustry Canada. Operation is subject to

the following two conditions: (1) This

device may not cause harmful interfer-

ence, and (2) this device must accept

any interference received, including in-

terference that may cause undesired

operation.

Changes or modifications not express-

ly approved by the party responsible

for compliance could void the user’s

authority to operate the equipment.

Two transmitters are provided for your ve-

y

Do not expose the transmitter to

severe shocks, such as those ex-

perienced as a result of dropping

or throwing.

y

Do not take the transmitter apart

except when replacing the bat-

tery.

y

Do not get the transmitter wet. If it

gets wet, wipe it dry with a cloth

immediately.

Advertising