Subaru 2006 Legacy User Manual

Page 235

Advertising
background image

6-18

Interior equipment

NOTE

y

After programming your HomeLink®

Wireless Control System for the de-

sired devices, retain the hand-held

transmitters for further programming

or device testing in the event of a prob-

lem.
y

It is recommended that you insert a

new battery in the hand-held transmit-

ter of a device to ensure correct pro-

gramming.

„

Garage door opener pro-

gramming in the U.S.A.

NOTE

When programming the HomeLink®

Wireless Control System for a garage

door opener, it is suggested that you

park the vehicle outside the garage.

1. Unplug the motor of the garage door

opener from the outlet.

2. Press and hold the two outside

HomeLink® buttons until the indicator light

begins to flash (after 20 seconds). Re-

lease both buttons.

NOTE

If any of the HomeLink® buttons are al-

ready programmed for other devices,

skip step 2 because it clears the mem-

ory of all the three buttons.

3. Hold the end of the garage door open-

er’s hand-held transmitter between 1 and

3 inches (25 and 76 mm) away from the

HomeLink® buttons on the driver’s sun vi-

sor, keeping the indicator light in view.

4. Using both hands, simultaneously

push the hand-held transmitter button and

the desired HomeLink® button. DO NOT

release the buttons until step 5 has been

completed.

5. Hold down both buttons until the

HomeLink® indicator light flashes, first

slowly then rapidly. When the indicator

light flashes rapidly, both buttons may be

released. (The rapidly flashing light indi-

cates successful programming of the new

frequency signal.)

6. Press and hold the programmed button

and check the HomeLink® indicator light.

If the indicator light stays on continuously,

your garage door should activate and the

programming is completed.

If the indicator light flashes rapidly for two

seconds and then stays on continuously,

When programming the HomeLink®

Wireless Control System to operate

a garage door opener or an entrance

gate, unplug the device’s motor

from the outlet during programming

to prevent motor burnout.

600430

600431

Advertising