Subaru 2006 Legacy - Manual (Page 63)

1-38
Seat, seatbelt and SRS airbags
lower anchorages; lift up the head re-
straint while pressing the release button.
Store the head restraint in the cargo area.
Avoid placing the head restraint in the
passenger compartment to prevent it from
being thrown around in the passenger
compartment in a sudden stop or a sharp
turn.
2. Open the cover flaps to use the an-
chorages.
3. Fasten the top tether hook of the child
restraint system to the appropriate upper
anchorage.
4. Tighten the top tether securely.
*SRS airbag (Supplemental
Restraint System airbag)
*SRS: This stands for supplemental re-
straint system. This name is used be-
cause the airbag system supplements the
vehicle’s seatbelts.
Your vehicle is equipped with a crash
sensing and diagnostic module, which will
record the use of the seatbelt(s) by the
driver and/or front passenger when any of
the SRS frontal, side and curtain airbags
deploys.
„ Vehicle with SRS airbags and
lap/shoulder restraints for
driver, front passenger, and
window-side rear passengers
Your vehicle is equipped with a supple-
mental restraint system in addition to a
lap/shoulder belt at each front seating po-
sition and each rear window-side seating
positions. The supplemental restraint sys-
tem (SRS) consists of six airbags.
The configurations are as follows:
y
Driver’s and front passenger’s frontal
airbags
y
Driver’s and front passenger’s side air-
bags
y
Curtain airbags (for driver, front pas-
100271
Always remove the head restraint
when mounting a child restraint sys-
tem with a top tether. Otherwise, it
may happen that the top tether can-
not be fastened tightly.
200308