Subaru 2006 Legacy User Manual
Page 44
Seat, seatbelt and SRS airbags
1-19
– CONTINUED –
2. Pull out the seatbelt slowly from the
overhead retractor.
3. After confirming that the webbing is not
twisted, insert the connector (tongue) at-
tached at the webbing end into the buckle
on the right-hand side until a click is heard.
If the belt stops before reaching the buck-
le, return the belt slightly and pull it out
more slowly. If the belt still cannot be un-
locked, let the belt retract slightly after giv-
ing it a strong pull, then pull it out slowly
again.
4. After fastening the seatbelt, make sure
that the “
” mark on the connector
(tongue) and the “
” mark on the buck-
le face outwards.
5. Insert the center seatbelt tongue plate
in the center seatbelt buckle marked
“CENTER” on the left-hand side until it
clicks.
6. To make the lap part tight, pull up on
the shoulder belt. And place the lap belt as
100735
100309
200298
100114
100310